Product/Service

Dyna-Jet Scrubbers

Source: Advanced Industrial Technology Corp.
Dyna-Jet is an improved jet-Venturi scrubber effective for gas absorption and particulate removal

  • EFFECTIVE GAS ABSORPTION AND PARTICULATE REMOVAL

  • SELF-INDUCTIVE, NEEDING NO FAN TO OPERATE

  • NO PLUGGING OR SOLIDS BUILD-UP PROBLEMS

  • IDEAL FOR FLUORIDE REMOVAL; S02 SCRUBBING WITH LIME, LIMESTONE, OR MAGNESIA; PHOSPHATE ROCK KILN OFF-GASES.

    Dyna-Jet is an improved jet-Venturi scrubber effective for gas absorption and particulate removal. By directing high pressure jet sprays into a Venturi, a zone of intense turbulence is created as the spray jets and the aspirated gases thrust forward. The accelerating spray droplets impact and capture dust particles and at the same time provide large contact surfaces for gas absorption. Dust laiden liquid droplets are subsequently separated from the clean gases in a separator. The jet sprays also serve to pump the gases through the system. Up to 2" w.c. available draft can be developed by Dyna-Jet to overcome pressure drop through ducting. Special high efficiency units, however, may have a pressure drop of several inches of water.

    The scrubbing efficiency of a Dyna-Jet varies depending on the nozzle pressure and the liquid to gas ratio used. Typically, a single stage unit can remove 90 - 98% of most soluble gases and 98 - 99% of particles over 2 microns.

    Advanced Industrial Technology Corp., P.O. Box 493, Paramus, NJ 07653. Tel: 201-265-1414; Fax: 201-262-8457.