Slit Separation System

J.J. Plank Corporation / Spencer Johnston Company Slit Separation System has two conventional Fixed Bow Spreader Rolls mounted on a rotating table. The unit is used as an after slitter system to separate the slits. Depending on which way the table is rotated, the amount of surface contact of the web to the rolls is either increased or decreased.

Since the spreading effect increases as the amount of wrap increases, the spacing between the slits can be infinitely adjusted to the desired width. This gives the operator an easy on-the-run adjustment of the slit spacing to correct for different grades, slitter table set-ups, and other variables. And, since these are conventional spreader rolls, the bows of these rolls can still be individually rotated.

Features include:

Dual spreader roll table arrangement

Uses two conventional spreader rolls

Complete system includes a before slitter roll

Spreader rolls can be either rubber or Steelclad

Spreader rolls have precise bows

Unit completely pre-assembled and optically aligned for ease installation

Slit separation can be infinitely adjusted by rotation of unit itself

<%=company%>, 728 Watermark Court, Neenah, WI 54956. Tel: 920-734-2563. Fax: 920-734-4885.